Manual Update Galaxy GRAND I9082 with Official Jellybean 4.2.2 XXUBMF2 Firmware – Guide

Samsung GRAND DUOS smartphone can now be updated with the Jellybean 4.2.2 Firmware which is dubbed as XXUBMF2. Though this firmware is not yet pushed by Samsung officially, this can be applied on all Samsung Galaxy GRAND smartphones. Before we proceed on to check on what are the instructions to apply this firmware update, you will have to make sure that you have followed all the quick pre requisites which are mentioned below.

Screenshot_2013-07-04-20-08-30 Screenshot_2013-07-04-20-04-43 Screenshot_2013-07-04-20-08-25 Screenshot_2013-07-04-20-08-59

Note: Please note that this is the Official firmware released by Samsung and is not a beta or custom ROM firmware.

Quick Pre Requisites:

  • All the data in your Samsung Galaxy GRAND smartphone should be backed up with the help of below mentioned steps. Don’t backup with the help of KIES as it may not help you restore the data back.

SMS – Use “SMS Backup & Restore app”,
Contacts – Sync with the Gmail application,
Call Log - Call Log and Restore
Images, Songs, Videos, Files – Copy to internal / External SD Card,
APN and MMS Settings – Note down from the path “Applications > Settings > Wireless and Network > Mobile Networks > Access Point Names

  • From the path “Settings > Applications > Development > USB debugging” enable the SUB Debugging Mode. Minimum charge left in your phone is 30% or else there is a risk of device getting turned off in the middle of firmware update increases which may even brick your Galaxy S3.

Disclaimer: Follow all the instructions mentioned in this article as if there is any damage caused due to not following instructions then we shall not be held liable or responsible. Just in case if you face any issues then we will try our level best to address the same.

Let’s proceed to the next step where we have mentioned a detailed guide on how to apply with this firmware update.

30 Comments
  1. Reply bidit July 30, 2013 at 7:58 pm

    can i do this on grand duos???

    • Reply Pradeep Neela July 31, 2013 at 11:37 am

      YES YOU CAN UPDATE THE SAME

  2. Reply youngdragon July 29, 2013 at 4:33 pm

    i9082 to 4.2.2’ve installed..to contacts 3 character by typing when I search on the person that came to a message or call dedigimde.bir next to the person registered on coming to the deficiency.

    • Reply Sameer September 23, 2013 at 9:20 am

      Yes am also facing the same problem. when you search any contacts and click on that same contact will not open, instead of next one will open.

  3. Reply mamad July 26, 2013 at 2:32 am

    Hi, this is a Persian-language version? Thank you

    • Reply Pradeep Neela July 31, 2013 at 11:54 am

      no, its in English

  4. Reply Swanand July 24, 2013 at 8:08 pm

    If this is official firmware, then why Samsung isn’t making it available? What is the use of delaying the roll out of this update?

    • Reply Pradeep Neela July 31, 2013 at 11:58 am

      yes its an official update

  5. Reply mamad228 July 24, 2013 at 3:52 am

    آیا زبان فارسی هم دارد؟

  6. Reply jomes July 23, 2013 at 2:21 am

    now there is a problem for coverage…..network is not troublesome..before the updating it was ok but after updating the phone network shows error or no network coverage….any recovery for the problem …please help

  7. Reply jomes July 20, 2013 at 11:58 pm

    i did it ….really good work…thank u

    • Reply Pradeep Neela September 1, 2013 at 12:24 pm

      thanks jomes for the beedback, we will keep you posted about the same v soon

  8. Reply rajesh patel July 19, 2013 at 2:09 pm

    hello dear praddep
    i am using galaxy s 2 GT I9100…..now i want to buy new phone so pls guide me which one i buy? galaxy grand or galaxy s4 ??if no any issue in galaxy grand so is it good one ??
    thanks
    RAJESH PATEL…INDIA

  9. Reply Ben July 17, 2013 at 11:44 am

    There are 4 tar files. Which sequence should i use?
    – BOOT_I9082XXUBMF2_REV05.tar
    – CODE_I9082XXUBMF2_871997_REV05_user_mid_noship.tar
    – CSC_OXA_I9082OXABMF2_871997_REV05_user_mid_noship.tar
    – MODEM_I9082XXUBMF2_REV05.tar

    • Reply Royce July 23, 2013 at 11:39 pm

      I posted the same query earlier, but from his reply it looks like the poster himself does not know.

      The article seems to be a cut/paste of another tutorial.

      It has no relation to the files actually obtained after extraction.

  10. Reply Suresh July 12, 2013 at 4:22 pm

    Cannot update please give full procedure

    • Reply Pradeep Neela July 16, 2013 at 12:28 pm

      where it is getting stuck?>

      • Reply Suresh July 16, 2013 at 1:11 pm

        Loads every thing but gets in to boot loop and when I try to wipe factory deta it shows as dead

  11. Reply Royce July 12, 2013 at 10:59 am

    After extracting, We get the following files …

    baffin.pit

    CSC_OXA_I9082OXABMF2_871997_REV05_user_mid_noship.tar.md5

    MODEM_I9082XXUBMF2_REV05.tar.md5

    BOOT_I9082XXUBMF2_REV05.tar.md5

    CODE_I9082XXUBMF2_871997_REV05_user_mid_noship.tar.md5

    You have only said “Click on “PDA” tab in the Odin to select the tar file which you got after extracting”

    Which tar file of the above ?
    What about baffin.pit ?

    • Reply Pradeep Neela July 19, 2013 at 12:13 pm

      boot is the one

      • Reply Royce July 23, 2013 at 11:37 pm

        Your tutorial is incomplete and does not match the files we get after extracting.

        I am doubtful about your answer : Use the boot …md5 file in PDA ? are you sure ?

        What to do with the other files ?

        I don’t think you actually saw the extracted files ? Looks like you just ‘cut-pasted’ from an older tutorial.

  12. Reply Roderick Echevarria Viado July 11, 2013 at 4:32 pm

    Its not working on my grand i9082. Did it twice and still not working. Going back to 4.1.2

  13. Reply roderick viado July 11, 2013 at 2:22 pm

    odin not functioning

  14. Reply Ayman July 10, 2013 at 5:35 pm

    mirror plz cant download from hotfile

    mediafire is awesome

    • Reply Pradeep Neela July 10, 2013 at 5:52 pm

      UNFORTUNATELY, DEVELOPER HAS MADE IT AVAILABLE ONLY ON HOTFILE

  15. Reply Suresh July 10, 2013 at 11:51 am

    Not updating please specify detailed procedure where to place baffin, boot, code, csc and modem

  16. Reply KZM July 10, 2013 at 10:39 am

    My Grand is I9082L. Can I update with this firmware?
    Thanks

    • Reply Pradeep Neela July 10, 2013 at 5:52 pm

      no, you cannot apply this update to I9082L Variant

  17. Reply kaushal July 10, 2013 at 4:05 am

    hello,

    i have big confusion please help me out

    In Odin : –

    PIT – baffin.pit (i select)
    Boot Loader – BOOT_I9082XXUBMF2_REV05.tar.md5 (i select)
    PDA – (i dont know which file i need to select)
    PHONE – (i dont know which file i need to select)
    CSC – CSC_OXA_I9082OXABMF2_871997_REV05_user_mid_noship.tar.md5 (i select)

    Please figure me out exact file location which should i select in odin because in sammobile.com the distribution is different.

    thank you in advance. reply me as soon as possible.

    • Reply Pradeep Neela October 4, 2013 at 9:06 pm

      perfect, all your file selections are correct. you can proceed with the latest release instead

Leave a reply

Human Verification: In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.