Samsung Galaxy FIT S5670L – Steps to Install Official Gingerbread UBKPI 2.3.6 Firmware
Samsung Galaxy FIT comes in many variants and one of the many variants bears the model number as S5670L for which too an all new Official firmware has arrived in the form of UBKPI for which we will be checking out the procedure in the due course. This firmware is official released for the users of Chile and can be applied by all the users of S5670L. If you are not sure of which model of Galaxy FIT you own then you can check the same by dialing *#1234#
Disclaimer: At Android Advices, we have made sure in all respects that all the information regarding the firmware update is mentioned correctly in this article. We should not be held responsible for any damage happened to your device in the process of updating your phone which is very unlikely if you follow the instructions.
So, let’s get started with the list of essential pre requisites which you need to follow after which we will check out on what is the procedure to install this new firmware in your S5670L Galaxy FIT.
Essential Pre Requisites:
- Backup all the data present in your FIT S5670L as in the process of applying this firmware, the data in the device may get deleted or corrupted.
ADVISORY (Not for CHILE users): Don’t backup the data using the KIES as after the update KIES won’t be detecting your phone as its not Official firmware for your region.
Text messages – Use “SMS Backup & Restore app”,
Phone Contacts – Sync with the Gmail application,
Call Log – Call Log and Restore
Pictures, Music, Videos, Files etc.– Copy to internal / External SD Card,
Internet & MMS Settings – Backup all the settings from the path “Applications > Settings > Wireless and Network > Mobile Networks > Access Point Names”
Notes – Manually you need to note down or need to transfer to Evernote.
- Battery left in the device should be a minimum of 60% so as to ensure that the device doesn’t get turned Off in the middle of firmware update. Enable the USB Debugging in your device from the path “Settings > Applications > Development > USB debugging”.
So, assuming that all the above instructions are followed successfully you are now ready to proceed with the procedure mentioned in the next page.