- Once you get into the download mode, you will have to connect the Galaxy S2 GT I9100 to the computer with the help of USB cable while Odin opened in the desktop. As soon as you connect the phone, you will see that first ID:COM box as shown below will turn yellow and in the message box you will see that it will show ADDED as shown in the below snapshot and after that you will have to add the files respectively as shown below,
- You will see that the ID:COM section will turn yellow, now you will have to select the corresponding files as mentioned below as it is or else you will end up bricking your phone and then you will be requiring JIG to un brick the same, so ensure that you double check before entering the files and also ensure that all the above steps are being followed properly.
PDA – PDA_DDJV9_Sbl.tar.md5,
Phone – PHONE_DDJV4.tar.md5,
CSC – CSC_ODDJV9.tar.md5
- You will have to note and double check the entries of the selection of files as mentioned above proceed and click on the “Start” option to start the firmware updation process. After clicking on the start, you will see that the firmware will be installed in your phone within a time of not more than 5 minutes. Now, as soon as the update is applied into the phone, the phone will process the update at the final stage which will be shown just like the below mentioned screen as in the message box you will see the message as “PASS” which shows that the firmware update was successful.
- As soon as he Galaxy S Phone reboots, you will have see the home screen and then choose the options accordingly and then after completion of Media scanning, you will have to go in the recovery mode wherein you will have to delete the cache memory so that all unwanted files are removed if there are any left in the phone.
- For going into the recovery mode, you will have to first turn off your device, long press the volume up key, press Menu as holding both the buttons press the power button to start. You can see that after device gets switched ON, you will find options like clear cache data. You can clear that by selecting options Wipe data/factory reset and also you need to select Wipe Cache partition after which you need to reboot your device by selecting reboot system now after which your Galaxy S will be rebooting and again you will have to set up your Google accounts etc. Doing this will not only optimize the battery but will also remove all the data flux from your phone.
Do, let us know if you face any of the problems as we will ensure that all problems are solved. Just in case if you have encountered with any issue or say if the firmware is interrupted in between then no need to panic as all you need to do is to just follow the upgrade instructions from the start so that the firmware gets installed without any issues.
