- Now, once the ID:COM section turns yellow, you will have to select the corresponding files as mentioned below as it is or else you will end up bricking your phone and then you will be requiring JIG to un brick the same, so ensure that you double check before entering the files and also ensure that all the above steps are being followed properly.
PIT – u1_02_20110310_emmc_EXT4.pit
PDA – I9100ZNKG5_I9100ZNKG5_I9100OZHKG5.tar
- Now, double check the entries or the selection of files as mentioned above proceed and click on the “Start” option to start the firmware updation process. After clicking on the start, you will see that the firmware will be installed in your phone within a time of not more than 5 minutes. Now, as soon as the update is applied into the phone, the phone will process the update at the final stage which will be shown just like the below mentioned screen as in the message box you will see the message as “PASS” which shows that the firmware update was successful.
That’s it you have now successfully flashed the new Chinese firmware on Galaxy S2 GT I9100. The device will be rebooted as soon as you see the above message. Since there is a cache memory of the previous firmware gets stored in the device, you will have to clear the same and which can be done by performing the full reset by dialing the short code *2767*3855# and then you will see that all the cache is cleared successfully. To check that version has been successfully updated or not you will have to type in the code as “*#1234#”. You will see that you will be on Gingerbread 2.3.4 version with the version name as ZNKG5 2.3.4 Gingerbread. So, we will also cover an article on how you can update with the latest version of firmware 2.3.5.
Do let us know on how is the new firmware and also let us know in the comments section below if you have any issues.
